Katydids
 | APQS Longarm Quilting Machine Dealer IntelliQuilter Dealer |  |
|
Inertia and Mass Newton's first law of motion states that "An object at rest tends to stay at rest and an object in motion tends to stay in motion with the same speed and in the same direction unless acted upon by an unbalanced force." Objects "tend to keep on doing what they're doing." In fact, it is the natural tendency of objects to resist changes in their state of motion. This tendency to resist changes in their state of motion is described as inertia. Because of inertia, an unwinding bobbin may accelerate too rapidly or continue to rotate in the unwinding direction after the thread ceases to be pulled from the bobbin. This results in loosened turns of thread commonly known as "backlash". This backlash is responsible for unsightly looking stitches commonly referred to as loops, bird nests, etc. Backlash, or over spin, occurs after the take-up lever has pulled the stitch tight. If allowed, the bobbin would continue to spin, causing the bobbin thread to be thrown out of the groove in the bobbin and causing very loose tension as the machine starts up again. Backlash is undesirable in all types of sewing machines. It is especially troublesome with high speed quilting machines where many starts, stops and changes in speed and direction are commonplace. Inertia is the primary cause of backlash. Mass as a Measure of the Amount of Inertia All objects resist changes in their state of motion. All objects have this tendency - they have inertia. But do some objects have more of a tendency to resist changes than others? Absolutely yes! The tendency of an object to resist changes in its state of motion is dependent upon mass. Inertia is that quantity which is solely dependent upon mass. The more mass which an object has, the more inertia it has - the more tendency it has to resist changes in its state of motion.  has almost half the mass of the
M bobbin and therefore almost half the resistance to changes in
its state of motion during quilting.
How our offers better stitch quality?
The top tension of a sewing machine controls the quality of the underneath stitch in your quilt and vice versa the bobbin tension controls the quality of the stitching that you can see on the top of your quilt. It is the top thread that is being taken, by your rotating hook, around the bobbin case (lower thread) and then pulled back up. Too little top tension will not bring the lower thread far enough, too much will pull the lower thread right through both layers of the quilt. Less bobbin inertia equals less necessary bobbin tension. Less bobbin tension then enables you to quilt with less top tension. The result is the beautiful stitch that is synonymous with all APQS long arm machines. Why our allows the quilter to enjoy a wide variety of thread types:
The top thread passes through the eye of the needle many times before it finally gets taken up in the quilt. You can see this for yourself, by marking the thread above the needle and watching it as you turn the machine by hand. Some thread types bear up to this rubbing through the needle eye much better than others. Lower operating tensions reduce the level of rubbing friction. Lower friction enables you to enjoy the incredibly wide range of thread types that are available today from the sturdier polyesters to the more delicate and fussy cottons, silks and specialty threads. The advantages of our :
Summary During high speed long arm quilting, our has the advantage of less mass. Less mass means less tension is required to overcome and control the inertia. Herein lies the secret to our beautiful stitch.
Return to Comparison Chart To Order: Call 850-729-0873 or e-mail: Patty@Katydids.net |
APQS Longarm Quilting Machines Main Page
Katydids, Inc.
105 Dominica Way
Niceville, FL 32578-4067
850-729-0873
patty@katydids.net
>